A network engineer has enabled BGP routing.
Which two additional features should the network engineer enable for BGP routing to function? (Choose two.)

Which two compression actions could a NetScaler engineer use? (Choose two.)

Scenario: The NetScaler has been connected to two external networks provided by different Internet Service
Providers (ISPs). Dynamic routing is not enabled. Traffic is expected to use the first ISP (through the 10.50.1.1
router) if possible and the second, slower ISP (through the 10.51.1.1 router) only if the Primary ISP fails.
Which two commands could the network engineer execute to configure the routes? (Choose two.)

When configuring an advanced HTTP callout based on attributes, what are two valid parameters? (Choose
two.)

Scenario: A network engineer configured a new NetScaler MPX appliance without any VLANs and with a single
interface connected to the network. The engineer has not completed any other configurations. The interface is
then accidentally disabled and contact is lost with the appliance.
Which two actions can the network engineer take to restore communications to the appliance? (Choose two.)

A security test has been completed on an SSL offload implementation and it has been determined that the
certificate key length is too short and must be increased.
Which two steps must the network engineer complete to resolve this? (Choose two.)

When binding a certificate to a virtual server, which two certificate formats are supported by NetScaler?
(Choose two.)

When configuring NetScaler authentication to access a web site, which two things should a network engineer
verify in the environment? (Choose two.)

A NetScaler engineer generates a techsupport archive to be sent to Technical Support.
Which three of the following pieces of information will be included in the archive file? (Choose three.)