You boot a Cisco TelePresence System TX1300. Six check marks appear in the lower left-hand corner. The IP
address 192.168.100.2 is displayed in the lower right-hand corner. A DHCP server is configured on the
network.
Which of the following statements is most likely to be correct?
A.
The CTS TX1300 and DHCP server are operating normally.
B.
The CTS TX1300 cannot reach the DHCP server.
C.
The CTS TX1300 does not have network connectivity.
D.
The CTS TX1300 has experienced a compact flash error.
Explanation:
The Cisco TelePresence System (CTS) TX1300 cannot reach the Dynamic Host Configuration Protocol
(DHCP) server. If the CTS TX1300 cannot reach a DHCP server, it will configure itself with the IP address
192.168.100.2. Therefore, you should check the DHCP server as well as the devices between the CTS TX1300
and the DHCP server.
The CTS TX1300 has network connectivity because the fourth circle in the lower left-hand corner displays a
check mark. If the fourth circle contains a red X, you should check the network port and the connected Ethernet
cable.
The CTS TX1300 has not experienced a compact flash error, because the sixth circle in the lower left-hand
corner displays a check mark. If the sixth circle contains a red X, the CTS TX1300 has experienced a compact
flash error. You should contact Cisco Technical Support if you receive this error.Cisco: First-Time Setup: Loading your Software and Initial System Configuration