Refer to the exhibit.
The network administrator cannot connect to Switch 1 over a Telnet session, although the hosts attached to Switch1 can ping the interface Fa0/0 of the router.
Given the information in the graphic and assuming that the router and Switch2 are configured properly, which of the following commands should be issued on
Switch1 to correct this problem?
A.
Switch1(config)# ip default-gateway 192.168.24.1
B.
Switch1(config)# interface fa0/1Switch1(config-if)# switchport mode trunk
C.
Switch1(config)# line con0Switch1(config-line)# password ciscoSwitch1(config-line)# login
D.
Switch1(config)# interface fa0/1Switch1(config-if)# ip address 192.168.24.3 255.255.255.0
E.
Switch1(config)# interface fa0/1Switch1(config-if)# duplex fullSwitch1(confiq-if)# speed 100
And, part of that new 718Q 200-125 dumps:
https://drive.google.com/open?id=0B-ob6L_QjGLpeHlmcExhU2FVY00
Best Regards!
0
0
What’s more, part of the new 750Q 200-125 dumps FYI:
https://drive.google.com/open?id=0B-ob6L_QjGLpeHlmcExhU2FVY00
Best Regards!
0
0
BTW, part of the new 765Q 200-125 dumps are available here:
https://drive.google.com/open?id=0B-ob6L_QjGLpeHlmcExhU2FVY00
Best Regards!
0
0
And, part of the new 808Q 200-125 dumps FYI:
https://drive.google.com/open?id=0B-ob6L_QjGLpeHlmcExhU2FVY00
Best Regards!
0
0