Refer to the exhibit.
An IPsec peer is exchanging routes using IKEv2, but the routes are not installed in the RIB.
Which configuration error is causing the failure?
A.
IKEv2 routing requires certificate authentication, not pre-shared keys.
B.
An invalid administrative distance value was configured.
C.
The match identity command must refer to an access list of routes.
D.
The IKEv2 authorization policy is not referenced in the IKEv2 profile.
“* If the administrative distance is 255, the router does not believe the source of that route and does not install the route in the routing table.” – http://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/15986-admin-distance.html
0
0
Thanks for the link
0
0
By the way, part of that new 307Q 300-209 dumps are available here:
https://drive.google.com/open?id=0B-ob6L_QjGLpVTNFVTRPdC0zTnM
Best Regards!
0
0