Refer to the exhibit.
What commands must be configured on the 2950 switch and the router to allow communication
between host 1 and host 2? (Choose two.)
A.
Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1
255.255.255.0 Router(config-if)# no shut down
B.
Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)#
interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip
address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(configsubif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0
C.
Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(configrouter)# network 192.168.20.0
D.
Switch1(config)# vlan database Switch1(config-vlan)# vtp domain XYZ Switch1(config-vlan)# vtp
server
E.
Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk
F.
Switch1(config)# interface vlan 1 Switch1(config-if)# ip default-gateway 192.168.1.1
Explanation:
http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a00800
949fd.shtml
https://learningnetwork.cisco.com/servlet/JiveServlet/download/5669-
2461/Router%20on%20a%20Stick.pdf.