nat (inside,outside) dynamic interface
A.
static PAT
B.
static NAT
C.
dynamic PAT
D.
dynamic NAT
Explanation:
Mr.W
Configuring Dynamic NAT
nat (inside,outside) dynamic my-range-obj
Configuring Dynamic PAT (Hide)
nat (inside,outside) dynamic interface
Source: http://www.cisco.com/c/en/us/td/docs/security/asa/asa83/configuration/guide/config/nat_objects.html
2017-8-2 New Updated 200-355 exam questions:
QUESTION 377
What is the effect of increasing antenna gain on a radio?
A. focusing energy in a defined direction
B. adding energy creating a larger cell
C. aligning phase shifting
D. improving frequency specific diversity
Answer: B
QUESTION 378
Which signal strength reading indicates that the engineer is closest to the access point?
A. -43 dBm
B. -67 dBm
C. -87 dBm
D. -100 dBm
Answer: A
QUESTION 379
The new tablets for the sales department require an SNR of 18 or more to operate. Given a noise floor of – 88 dBm, what is the minimum RSSI that is needed?
A. -60 dBm
B. -70 dBm
C. -72 dBm
D. -80 dBm
E. -96 dBm
F. -106 dBm
Answer: B
QUESTION 380
Refer to the exhibit. A network engineer needs the far end of a wireless bridge to receive at -45dBM.
image_thumb
Based on the diagram, what value in dBm must the transmitter use to send to achieve the desired result?
A. -118
B. -28
C. -20
D. 20
E. 28
F. 118
Answer: E
QUESTION 381
Refer to the exhibit. A wireless engineer has an antenna with the radiation pattern shown in the exhibit. What type of antenna is it?
image_thumb[1]
A. Patch
B. Yagi
C. Parabolic dish
D. Dipole
E. Internal omni
Answer: B
QUESTION 382
When reading a radiation pattern for an antenna, at which two drops in signal and power is the beamwidth measured? (Choose two.)
A. 3 dB
B. 6 dB
C. 9 dB
D. 10 dB
E. 1/2 power
F. 1/4 power
G. 1/8 power
H. 1/10 power
Answer: AE
QUESTION 383
When calculating the link budget for a wireless point-to-point bridge, the engineer notices that one antenna has its gain marked as 2.85 dBd. With a 20-mW access point and 3-dBi loss for the cable, what is the approximate EIRP?
A. 15 dBm
B. 18 dBm
C. 22 dBm
D. 25 dBm
Answer: A
QUESTION 384
Due to the terrain, a deployment requires a point-to-point wireless bridge to allow for network connectivity to a remote building. What 5GHz band would permitted to use the highest power in the U.S.?
A. U-NII-3
B. U-NII-2 Extended
C. U-NII-2
D. U-NII-1
Answer: A
QUESTION 385
A wireless engineer is designing a network for the London branch of a company. Which 5-GHz band allows the branch to use the highest EIRP?
A. 2.4-GHz ISM
B. UNII-1
C. UNII-2
D. UNII-2 Extended
Answer: D
More new 200-355 exam questions:
https://drive.google.com/drive/folders/0B75b5xYLjSSNRmRpZmZRdkotbUk?usp=sharing
0
0
Thats for wireless dumbass. This section is for security
0
0
besides, 2017 latest 200-355 PDF and 200-355 VCE 459q&as:https://www.braindump2go.com/200-355.html, they updated new questions everyday in step with official exam center, can have a read.
0
0