What is the reason no other messages are shown?
You observed that one of your Brocade DCX 8510-8s experienced a failover. You logged into the
switch and ran errshow to determine why the failover occurred, but nothing besides the failover
message was displayed.
What is the reason no other messages are shown?
which feature would you implement on Router B to accomplish this?
You want to mirror the tagged VLAN traffic from Router A to the collector, but the mirrored traffic
must go through Router B to reach the collector.
Referring to the exhibit, which feature would you implement on Router B to accomplish this?
What is generating the error?
Traffic isolation zones are configured as shown in the exhibit. The RASLog message has indicated
a potential error. In troubleshooting the command zone –showTIerrors produces the output in the exhibit.
What is generating the error?
What would cause this?
You notice a high amount of packet fragmentation messages on the router.
What would cause this?
What is the problem?
An FCIP tunnel between two Brocade 7800s is bouncing online then offline. The service provider
said the link is experiencing errors.
What is the problem?
What are two results?
You work on a large distributed network that includes 30 Brocade MLXe series routers. One of
your MLXe routers has logged a series of TCN notifications.
What are two results? (Choose two.)
Which action determines if the connected FCIP tunnel is dropping the frames?
The network administrator is notified of a port login problem occurring between two devices across
an FCIP tunnel. “Supportsaves” were taken on both end switches to determine if the frames were
being dropped on the FC links or by the switch blades. Support has concluded that frames were
not dropped.
Which action determines if the connected FCIP tunnel is dropping the frames?
What is causing this to happen?
Your network has gone through a security overview and hardening. Your BGP router has now lost
connectivity. What is causing this to happen?
What would cause this?
You have configured a BGP router to communicate to a peer from a specific loopback. During
implementation, you discover you are not peering. What would cause this?
What are two explanations for this?
You discover that the Brocade FastIron has increased CPU utilization.
What are two explanations for this? (Choose two.)