Which two statements are true?
You must configure a long distance link to use idle fill words.
Which two statements are true? (Choose two.)
What must you do to apply the changes?
You have changed the outbound policy on a BGP router.
What must you do to apply the changes?
Which two statements are true?
You were asked to use the portcfgfillword command to configure a long distance link between two
Brocade 6510s.
Which two statements are true? (Choose two.)
What would explain this?
You install a router configured to run OSPF. You issue show ip ospf neighbor and notice that the
neighbor remains in the INIT state. What would explain this?
How would you resolve this problem without removing legacy devices from the fabric?
After installing new 16 Gbps switch products, you run the bottleneckmon command. A console
message reports congestion bottlenecks are present on several ports.
How would you resolve this problem without removing legacy devices from the fabric?
Which two statements are true?
You have a Brocade IronStack of four FCX units actively running with sequential unit IDs. You
need to replace unit ID 3 with a new unit. Which two statements are true? (Choose two.)
What will happen when the test is run?
You have attached a new Brocade DCX 8510-8 using one ISL to an existing fabric. The new DCX
8510-8 has merged into the fabric, but it is showing several connection errors over the span of a
few hours. You decide to run the D_Port diagnostic test on the ISL from the DCX 8510-8 using
Brocade Network Advisor.
What will happen when the test is run?
What would cause the second port from functioning?
You have installed a new 2 x 100 GbE interface module into a Brocade MLXe. The first port is
functional, however, the second port on the module is not functional.
What would cause the second port from functioning?
which two statements are true?
Referring to the exhibit, which two statements are true? (Choose two.)
What is causing this?
After hot swapping an interface module (LP) on a Brocade MLXe, the interface module boots up to
an interactive state, instead of an active state.
What is causing this?