Which two Brocade products are recommended for core/aggregation use?
Which two Brocade products are recommended for core/aggregation use? (Choose two.)
Which two statements are true for multicast traffic ingressing into a Brocade VCS fabric on a Vlag with IGMP s
Which two statements are true for multicast traffic ingressing into a Brocade VCS fabric on a Vlag
with IGMP snooping enabled? (Choose two)
What is required?
You are designing a SAN using a Brocade DCX 8510-4 that will extend over a distance of 50 km
using native Fibre Channel. You will be using 10 Gbps Wave Division Multiplexing connections.
What is required?
Which feature must be disabled on the edge ports?
A customer is considering a Brocade VCS Fabric for their environment and the Spanning Tree
Protocol (STP) is required outside the fabric. Which feature must be disabled on the edge ports?
which two tasks must be configured to accomplish the goal?
Your customer’s Web site is designed to send a client to a different Web page based on the client
IP address using HTTP redirects. For compliance reasons, traffic now needs to be encrypted but
they do not want to make any modifications on the application.
After installing a Brocade ADX, which two tasks must be configured to accomplish the goal?
(Choose two.)
Which feature enhances performance for the N_Ports?
You notice that some N_Ports on a Brocade 6510 in Access Gateway mode are heavily used
while others are not. You want to balance the utilization.
Which feature enhances performance for the N_Ports?
How would you ensure that the router becomes the DR?
You have a router that you want to become an OSPF DR. All routers in the area are currently set
at the default values. How would you ensure that the router becomes the DR?
Which two statements about ICL links in Brocade Multi-Chassis Trunk (MCT) implementations are true?
Which two statements about ICL links in Brocade Multi-Chassis Trunk (MCT) implementations are
true? (Choose two.)
which command would be needed in VDX 1 to enable a RIP route to propagate into OSPF Area 0?
Which solution would satisfy this request?
You have been asked to complete a fabric design for three fully populated DCX 8510-8s with FC8-64 blades. The requirements are for 1024 user ports available on the edge with two hops from
initiator to target communications. Which solution would satisfy this request?