Which Brocade feature will meet this requirement?
You are asked to optimize your customer’s design to ensure that the tape backup traffic will be
prioritized when congestion occurs. The fabric consists of two Brocade 6510s connected with a 64
Gbps ISL trunk. Which Brocade feature will meet this requirement?
which two configuration changes are needed?
A network administrator wants to perform SSL offload (acceleration) but the configuration is not
working.
Referring to the exhibit, which two configuration changes are needed? (Choose two.)
Which two modes can you configure?
You want to install Top Talkers in your fabric.
Which two modes can you configure? (Choose two.)
How would you accomplish this?
You have learned a route from RIP and OSPF. You would prefer the RIP route to be active instead
of the OSPF route. How would you accomplish this?
What is the default administrative distance for RIP?
What is the default administrative distance for RIP?
which switch would be elected as the Principal RBridge?
Referring to the exhibit, which switch would be elected as the Principal RBridge?
Which two solutions will ensure that there will be minimal signal loss for the end nodes?
A customer has performance concerns about exceeding the cable lengths between 16 Gbps
nodes on a fiber link. There are hundreds of OM4 multi-mode fiber links across the data center
that exceed the 125 m fiber link loss budget. Which two solutions will ensure that there will be
minimal signal loss for the end nodes? (Choose two.)
Which monitoring utility would you use?
You believe you have a server that is timing out. In Fabric OS v7.0 you want to find discarded
frames due to timeout reasons.
Which monitoring utility would you use?
which prefix?
A Brocade device automatically configures a link-local unicast address for an interface by using
which prefix?
Which two actions must the customer perform to comply with the requirement?
A customer has been performing Layer 7 load balancing HTTP traffic using a non-SSL Brocade
ADX 1000. For compliance reasons, full encrypted connectivity is required from the client to the
server using SSL. Which two actions must the customer perform to comply with the requirement?
(Choose two.)