What is the minimum configuration required to enable AVT for a MSR2000 in a mesh network?

Which of the following actions could improve the SNR value of a link that is up but has a poor
quality? Choose all that apply:

Which of the following actions can help you determine why a link is not stable?

You have deployed a point-to-point network with two nodes, their hostnames are “Node-1” and
“Node-2.” At the time of deployment, iPerf shows the bandwidth of the link to be 35 Mbps and
stable. A week later, customer is complaining that the link has become unstable. It often goes
down and delivers less than 5Mbps when up. What are the least likely reasons for this problem?
Choose all that apply.

A node has dropped from the mesh network and you were not able to debug the issue remotely.
Instead, you have come to the problem node’s location to troubleshoot it. Which of the following
actions can help you identify the problem cause? Choose all that apply.

What effect does multipath fade have on the signal at the receiver?

Which frequency bands require DFS certification by the FCC?

What is the maximum data rate specified for IEEE 802.11n WLANs using 20Mhz channel in 2×2
mode?

List the 802.11e access categories from highest priority to lowest.

What of the following statements about Mobility Matrix is true?