Which of the following functions can be configured in the Controller WIP wizard? (Choose
three)

A client device associates with an SSID provisioned with 802.1X authentication. The client is
set for PEAP authentication. EAP termination (AAA Fastconnect) is disabled on the
controller. But the client continuously cycles through the authentication process. Which of
the following could cause this? (Choose two)

A client device associates with an SSID provisioned with 802.1X authentication. The client is
set for LEAP authentication. EAP termination (AAA Fastconnect) is enabled on the
controller. But the client continuously cycles through the authentication process. Which of
the following could cause this?

A client attaches to a secure jack interface set to untrusted. But when the client tries to
access the captive portal page, the following message appears, “Web Authentication is not
enabled.” What might be wrong?

Which command, when executed on a master controller, will show the APs connected to all
controllers?

Which of the following commands is most useful in showing the traffic of an individual user?

An Aruba based network has a Master and four local controllers deployed. But one of the
locals, a new installation, is not seen by the Master. What might be wrong? (Choose two)

An Aruba controller is configured with the correct IP address and gateway information and is
connected to the corporate LAN via a core layer 2 switch. Control Plane Security is not
enabled on the network. An access point is provisioned with AP name and group and
connected to a different Layer 2 switch on the corporate LAN that has IP connectivity to the
core layer 2 switch. The AP powers on and layer 2 connects to the network, but the wireless
radios do not power on.
Which could cause this condition? (Choose two)

In the diagram provided for this question, four buildings are identified on a college campus.
Most of the wireless LAN traffic will be from students accessing the internet.

According to Aruba best practices, which building is the best location to install the Aruba mobility controller?

Referring to the diagram provided for this question, representing an office wireless LAN
deployment, there will be approximately 250 users in the offices section of the building. All
Switches are setup as L3 routers.

According to Aruba best practice, which network device is the best choice for the wireless
clients’ default gateway?