Referring to the above screen capture,

which tab tells you which licenses are installed on the controller?

A client attaches to a secure jack interface set to untrusted. But when the client tries to access the
captive portal page, the following message appears, “Web Authentication is not enabled.” What
might be wrong? Choose all that apply.

A client device associates with an SSID provisioned with 802.1X authentication. The client is set
for LEAP authentication. EAP termination (AAA Fastconnect) is enabled on the controller. But the
client continuously cycles through the authentication process. Which of the following could cause
this?

A client device associates with an SSID provisioned with 802.1X authentication. The client is set
for PEAP authentication. EAP termination (AAA Fastconnect) is disabled on the controller. But the
client continuously cycles through the authentication process. Which of the following could cause
this? Choose all that apply.

Referring to the screen captures provided for this question,

what can you conclude about the two clients from the Packet Rate Distribution screens?

In the diagram provided for this question, four buildings are identified on a college campus.

Most of the wireless LAN traffic will be from students accessing the internet.
According to Aruba best practices, which building is the best location to install the Aruba mobility
controller?

An Aruba controller is configured with the correct IP address and gateway information and is
connected to the corporate LAN via a core layer 2 switch. An access point is provisioned with AP
name and group and connected to a different switch on the corporate LAN that has IP connectivity
to the core layer 2 switch. The AP powers on and connects to the LAN, but the wireless radios do
not power on.
Which could cause this condition? (Choose all of the correct answers.)

An Aruba based network has a Master and four local controllers deployed. But one of the locals, a
new installation, is not seen by the Master. What might be wrong? Choose all that apply.

Which of the following commands is most useful in showing the traffic of an individual user?

Which command, when executed on a master controller, will show the APs connected to an lms?