(group8) #show ap arm history ap-name AP1
Interface :wifi0
ARM History
———–
Time of Change Old Channel New Channel Old Power New Power Reason
————– ———– ———– ——— ——— ——
2010-10-28 07:58:53 157+ 149+ 21 21 I
2010-10-28 07:52:06 149+ 157+ 21 21 M
2010-10-28 07:16:59 157+ 149+ 21 21 I
Interface :wifi1
ARM History
———–
Time of Change Old Channel New Channel Old Power New Power Reason
————– ———– ———– ——— ——— ——
2010-10-28 08:52:53 6 1 21 21 I
Referring to the output above. What can you conclude about AP1?

Which of the following parameters can be specified in a rule for AP classification? (Choose
three)

Which of the following functions can be configured in the Controller WIP wizard? (Choose
three)

A client device associates with an SSID provisioned with 802.1X authentication. The client is
set for PEAP authentication. EAP termination (AAA Fastconnect) is disabled on the
controller. But the client continuously cycles through the authentication process. Which of
the following could cause this? (Choose two)

A client device associates with an SSID provisioned with 802.1X authentication. The client is
set for LEAP authentication. EAP termination (AAA Fastconnect) is enabled on the
controller. But the client continuously cycles through the authentication process. Which of
the following could cause this?

A client attaches to a secure jack interface set to untrusted. But when the client tries to
access the captive portal page, the following message appears, “Web Authentication is not
enabled.” What might be wrong?

Which command, when executed on a master controller, will show the APs connected to all
controllers?

Which of the following commands is most useful in showing the traffic of an individual user?

An Aruba based network has a Master and four local controllers deployed. But one of the
locals, a new installation, is not seen by the Master. What might be wrong? (Choose two)

An Aruba controller is configured with the correct IP address and gateway information and is
connected to the corporate LAN via a core layer 2 switch. Control Plane Security is not
enabled on the network. An access point is provisioned with AP name and group and
connected to a different Layer 2 switch on the corporate LAN that has IP connectivity to the
core layer 2 switch. The AP powers on and layer 2 connects to the network, but the wireless
radios do not power on.
Which could cause this condition? (Choose two)