Refer to the exhibit.
Exhibit Switch configuration
A network administrator is configuring an aggregated link between an HP Comware and ProVision
switch. The network administrator applies the configurations to the switches, as shown in the
exhibit. The two links on the both switches are up, and they can see each other on both links in the
local LLDP table.
What will be the outcome?
A.
The ProVision switch must initiate LACP for the link become active
B.
Link aggregation fails because the VLAN tagging was not configured correctly
C.
The Commware switch must initiate LACP for the link to become active
D.
Link aggregation fails because of a protocol issue
This is incorrect. The command link-aggregation mode dynamic initiates LACP for the comware side of the aggregation.
The answer should be A since the trunk command on the ProCurve switch does not have LACP at the end (indicating a manual/static Link aggregation with no LACP protocol)
For this link aggregation to work, the trunk command for the ProCurve should be this:
trunk A1-A2 trk1 lacp
0
0