HOTSPOT
Match the appropriate HP best practices rack location with each listed component to configure the
rack shown.

You have a c7000 enclosure with 1 GB Pass-Thru modules. You cannot get to the network from
any of the blades. What should you verify first for proper connectivity to the network?

When installing DDR3 memory DIMMs for Gen8 servers shown, which order of slots should be
followed?

A customer replaced the memory DIMM several times in the same slot on a BL460c G7 Server.
What are the next troubleshooting steps? (Select two.)

You are doing troubleshooting and need to access a single server blade console. Which
configuration option is the best to use?

After replacement of a BL460c G7 system board, the server is unable to connect to an external
shared storage through the SAS interface. Other similar servers in the same enclosure are in
working condition.
What should you check to verify that the physical hardware connectivity is connected?

You installed an FC HBA in mezzanine slot 2 of a BL460c G6 in a c7000 enclosure. In which
interconnect bays should the FC interconnect be installed?

How many half-height blades can you install in the enclosure shown?

Where can you verify the status of an external DVD-ROM drive in a c7000 enclosure?

You are installing a new HP BladeSystem c7000 enclosure. The customer wants to configure the
iLO and interconnect IPs so that they are automatically maintained during a hardware swap.
How should you configure the enclosure?