At a customer site, you have configured static linkaggregation between an HP E8212 zl switch and an HP
E5406 zl switch. The aggregated link includes
two ports on each switch. During testing, traffic analysis reveals that only one of the links is beingused to full
capacity. The other link is
operating well below capacity.What is an accurate explanation for this finding?

An HP A-Series switch includes the following configuration:

Which VLANs are in instance 0?

You have successfully installed an HP PCM+ remote client on a network administrator’s workstation. Which
step is necessary to enable the client to
access the PCM+ server ?

You must configure VLANs and ports on an HP A7500 switch at default settings. What is the effect of the
following commands?
[SW-Gigabit-Ethernet1/0/1]port link-type trunk
[SW-Gigabit-Ethernet1/0/1]port trunk permit vlan 100 101

Refer to the Exhibit.

What does the output shown in the exhibit indicate about this HP E3500-24G yl switch? (All switches inthe
Spanning Tree are at default settings.)

You must configure static link aggregation using LACP between an HP E5406 zl switch and an HP E8212 zl
switch. What must match on all ports that will
be included in the aggregated link? (Select three.)

What is an advantage of using a ring topology when designing an IRF stack using A-Series switches?

You enter the following command at the CLI of an HPE5412 zl Series switch:Switch(config)# spanning-tree
priority 3Which Bridge Priority value is
displayed when you enter show spanning-tree?

You must define a hostname on an HP E5400 zl Seriesswitch. Which configuration context must you enterto
perform this task?

What is the default protocol when a link aggregation group is defined on an HP A-Series switch?