What are correct peer statements for completing the con…
Refer to the exhibits.
Exhibit 1.
Exhibit 2
A network administrator is setting up a VPLS solution to connect sites 1, 2, and 3. Exhibit 2 shows part of the
configuration. What are correct peer statements for completing the configuration?
Which statement is true concerning spanning tree protoc…
Which statement is true concerning spanning tree protocols and HP switches?
What is a valid configuration?
An HP Comware switch has four MDCs defined on it. Network administrators need to set up SSH access to
each MDC and want to use the Management-Ethernet interface for that purpose. What is a valid configuration?
which of the following must you perform first?
When adding a new member to an existing IRF domain, which of the following must you perform first?
What must the network administrator do on interface Ten…
Refer to the exhibits.
Exhibit 1
Exhibit 2
The switch and server will transmit Fibre Channel over Ethernet (FCoE) traffic on the Ethernet link. If
congestion occurs, the devices should pause the FCoE transmissions rather than drop them. What must the
network administrator do on interface Ten-GigabitEthernet 1/0/2 to enable this behavior?
Which Comware configuration will allow the three VLANs …
An HP Provision switch has port A1 connected to port g1/0/1 of an HP Comware switch. The ProVision port has
the following configuration: vlan 1 untag A1 vlan 10 tag A1 vlan 20 tag A1
Which Comware configuration will allow the three VLANs to successfully pass traffic between the two switches?
What is a benefit of the HP Network Protector SDN Appli…
What is a benefit of the HP Network Protector SDN Application as opposed to a traditional IDS/IPS?
which view must an administrator access in order to exe…
On an HP Comware switch, which view must an administrator access in order to execute the debug command?
Which common data center requirement does an HP EVI sol…
Which common data center requirement does an HP EVI solution meet?
which ProVision command should the network administrato…
A customer has an HP ProVision switch capable of Layer 3 forwarding: however, Layer 3 forwarding is
disabled. The switch has an IP address in the management VLAN, where the default gateway is 10.1.1.1, which
ProVision command should the network administrator use so the ProVision switch can access the Intelligent
Management Center (IMC) server in a different VLAN?