Which setup establishes the desired connections?
Refer to the exhibit.
A network administrator is setting up MPLS Layer 2 VPN connections between several customer sites:
Connection 1 = Customer Site 1 to customer Site 2
Connection 2 = Customer Site 1 to customer Site 3
The administrator has established two pseudowires (PW) on PE-1, as shown in the exhibit. On PE-1, interface
GigabitEthernet1/0/1 connects to CE-1 at Site 1. Which setup establishes the desired connections?
Which HP Comware term defines the untagged VLAN on a tr…
Which HP Comware term defines the untagged VLAN on a trunk port that is commonly used for network
management traffic?
Which requirement does EVI selective flooding help admi…
Which requirement does EVI selective flooding help administrators fulfill?
Where is priority information stored in an Ethernet frame?
Where is priority information stored in an Ethernet frame?
Which switch OpenFlow instance setting meets this requi…
A company has a team of HP VAN SDN Controllers. On several Comware switches, the network administrator
configures two controller IP addresses in the OpenFlow instance. The SDN application requires that the
switches perform the fastest failover from one controller to another.
Which switch OpenFlow instance setting meets this requirement?
What should the administrator do to accomplish this?
Refer to the exhibit.
The switches in the exhibit are all HP ProVision switches that run Multiple Spanning Tree Protocol (MSTP).
The network administrator wants all of the switch-to-switch links shown in the exhibit to be available for
forwarding routed traffic. What should the administrator do to accomplish this?
What must be corrected?
Refer to the exhibit.
A network administrator wants to use Application TLVs to communicate application priority information to a
Converged Network Adaptor (CNA). The administrator has configured the QoS policy shown in the exhibit for
this purpose and applied the policy outbound to the interface connected to the CAN. The solution is not working
correctly.
What must be corrected?
where should the administrator configure DHCP relay?
Refer to the exhibit.
The physical interfaces for Comware-1 and Comware-2 switches in the exhibit are configured in routed mode
and OSPF. Both switches have the three subnets in their routing tables. The administrator wants to use DHCP
to assign addressing information to the users. Based on the exhibit, where should the administrator configure
DHCP relay?
Which HP product meets these needs?
A customer requires greater visibility and insight into traffic flowing between virtual machines (VMs) on the
same ESXi host. Which HP product meets these needs?
What is correct about the domain and member IDs in this…
A network administrator configures several HP Comware switches to be part of a single Intelligent Resilient
Framework (IRF) virtual device. What is correct about the domain and member IDs in this configuration?