Which command defines a default route on an HP Provision switch when routing has been enabled?
Which command defines a default route on an HP Provision switch when routing has been
enabled?
Which HP protection feature effectively manages this problem?
A user brings a generic switch from home into a company. The user switch does not support any
Spanning Tree protocols. The user switch has two connections to the network on switch ports that
are defined as edge ports. Assume the company switches are HP Provision switches.
Which HP protection feature effectively manages this problem?
Which configuration tool do HP Provision switches support that HP Comware switches do not support?
Which configuration tool do HP Provision switches support that HP Comware switches do not
support?
What is the probable cause of the error message when the network administrator tries to copy the file?
Which statement is true about using the RADIUS protocol for AAA functions’?
Which statement is true about using the RADIUS protocol for AAA functions’?
Which solution should the network administrator use to fix the problem?
A network administrator receives a new HP Provision switch and notices that the software version
running on the switch is older than what is currently used in the network. The network
administrator copies an updated version of the operating system from the new switch’s USB port
to the secondary flash location. The network administrator then executes the following command:
Provision# boot system flash secondary:
The switch reboots using the new operating system. However, when the network administrator
turns off the switch and turns it back on, the switch boots from the old operating system.
Which solution should the network administrator use to fix the problem?
What is the console port designation for an HP Comware switch?
What is the console port designation for an HP Comware switch?
which IP address does the user generate an ARP?
Which command should the network administrator execute to undo the misconfiguration?
A network administrator executes this command on an HP switch:
Provision (config)# vlan 11 untag Al
The network administrator immediately realizes that the port that was specified in the command
was the wrong port. Port A1 should remain in its original VLAN, VLAN 1. Which command should
the network administrator execute to undo the misconfiguration?
Which URL can a network administrator use to access Intelligent Management Center (IMC)?
Which URL can a network administrator use to access Intelligent Management Center (IMC)?