A network administrator attempts to create a loopback interface on an HP Comware switch, and it
fails. These are the commands the network administrator issues to do this.
[Comware] interface loopback 2
[Comware-Loopback2] ip address 172.18.20.1 255.255.255.0
What is the problem with the proposed configuration/

A network administrator configures this command on an HP ProVision Switch:

Vlan 30 ip helper-address 10.0.3.253
After the network administrator configures the command, using in VLAN 30 report that their PCs
fail to acquire addresses using DHCP. Which command must the network administrator add to the
ProVision switch configuration to solve this problem?

Refer to the exhibit.
Exhibit: Network diagram and routing tables

Why does traffic from PC1 fail to reach PC2?

Refer to the Exhibit.
Exhibit: HP Comware switch configuration.
[Comware] vlan 100
[Comware-vlan100] quit
[Comware] vlan 200
[Comware-vlan200] quit
[Comware] interface g1/0/22
[Comware-GigabitEthernet1/0/22] port link-type trunk
[Comware-GigabitEthernet1/0/22] port trunk permit vlan 100 200
[Comware-GigabitEthernet1/0/22] quit

A network administrator configures the Comware switch, as shown in the exhibit. The network
administrator then connects a cable from the Comware’s g1/0/22 interface to port 5 on an HP
ProVision switch. Which configuration will successfully establish connection for VLAN 1, 100, and
200 between the two switches?

Which HP solution delivers automated virtual machine orchestrator, automatic synchronization of
network connectivity information, and visibility to performance of wired and wireless users?

Which method of link aggregation do both HP ProVision and Comware switches support?

What is a valid reason to choose an 802.11a wireless implementation?

A customer has an HP ProVision switch capable of Layer 3 forwarding: however, Layer 3
forwarding is disabled. The switch has an IP address in the management VLAN, where the default
gateway is 10.1.1.1, which ProVision command should the network administrator use so the
ProVision switch can access the Intelligent Management Center (IMC) server in a different VLAN?

On an HP Comware switch, which view must an administrator access in order to execute the
debug command?

An HP Provision switch has port A1 connected to port g1/0/1 of an HP Comware switch. The
ProVision port has the following configuration: vlan 1 untag A1 vlan 10 tag A1 vlan 20 tag A1
Which Comware configuration will allow the three VLANs to successfully pass traffic between the
two switches?