Refer to the network and ARP table exhibit.

The user on the left side of the exhibit wants to build a connection to the server on the right
Assume that SwitchA and SwitchB are HP Comware switches. For which IP address does the
user generate an ARP?

A network administrator wants to redirect log messages on the HP Comware switches to a syslog
server. Which configuration implements the desired result?

Which HP Provision and HP Comware commands restore a configuration file from a TFTP server
to the switches’ flash? (Select two.)

Refer to the partial command output.

Based on this output, which statement is true?

A network administrator receives a new HP Provision switch and notices that the software version
running on the switch is older than what is currently used in the network. The network
administrator copies an updated version of the operating system from the new switch’s USB port
to the secondary flash location. The network administrator then executes the following command:
ProVision # boot system flash secondary
The switch reboots using the new operating system. However, when the network administrator
turns off the switch and turns it back on, the switch boots from the old operating system. Which
solution should the network administrator use to fix the problem?

Which IMC agent starts and stops the IMC server and allows a network administrator to view the
status of the IMC processes?

A network administrator configures the following information on an HP Provision switch:
Provision(config)# spanning tree
Provision(config)# spanning tree instance 0 priority 2
Based on this information, what is the priority assigned to this switch for instance 0?

A network administrator enables debug to troubleshoot an OSPF adjacency on an HP Comware
switch. The network administrator then disables and then re-enables an interface connected to
another switch running OSPF. After waiting for a few minutes, no output displays on the console.
Which action must the network administrator take to resolve this problem?

What are factory default configuration settings of the HP MSM access points (APs)? (Select two.)

A network administrator is setting up OSPF between an HP Provision and HP Comware switch.
Once the configuration is finished, the network administrator sees log messages in the Comware
session about the successful establishment of the adjacency. However, the network administrator
does not see similar messages on the Provision console.
How can the network administrator see these log messages about the new OSPF adjacencies on
the Provision console?