View the exhibit.
Exhibit 1

Exhibit 2

PIM-SM is configured on each interface in the network and IGMP is enabled on VLAN 3 and VLAN
4, as shown in Exhibit 1. Each switch has a rendezvous point (RP) set and valid unicast routes, as
shown in Exhibit 2.
The network administrator configures an endpoint connected to VLAN4 to begin listening on
239.255.1.1 to verify if multicast routing configuration is established correctly. The network is not
live, meaning no other hosts are sending IGMP requests. The network administrator then checks
PIM routing entries on the switches to verify if the system is functioning correctly.
On which switches should (*, 239.255.1.1) entries appear if the system is functioning correctly?

View the exhibit.
Exhibit 1

Exhibit 2

A host connected to routing switch A joins group 239.0.0.1. Which switch does routing switch A
select as the RP?

A network uses PIM-DM to route multicast traffic. The network administrator has noticed bursts of
congestion related to periodic floods of multicast traffic. How can the administrator eliminate these
periodic bursts?

View the exhibit.
Exhibit 1

Exhibit 2

All switches shown in Exhibit 1 are HP Provision ASIC switches, which are implementing IGMP
and multicast routing with PIM. Routing switch B has just received the message shown in Exhibit 2
from routing switch A.
What can the network administrator assume?

View the exhibit.

An HP 5400 zl switch implements the configuration shown in the exhibit. However, when the
network administrator tests the configuration, endpoints in VLAN 10 do not obtain global IPv6
addresses. What might be causing this issue?

View the exhibit.

A site features both IPv6 and IPv4 endpoints and IPv4 and IPv6 capable servers in the data
center, as shown in the exhibit. How can the network administrator configure the HP 8200 zl
switch at the core to work in this environment?

Two HP 7500 switches, switch A and switch B, are implementing VRRP in VLAN 2 (VRID 2) and
in VLAN 3 (VRID 3). Switch A is currently the master in both VRIDs. The network administrator

enables load balancing on both VRIDs on both switches.
Which statement describes an effect of these commands?

Which type of IPv6 over IPv4 tunnel protocol on an HP 12500 switch requires that you specify a
destination?

A network administrator enabled IPv6 on an HP 7500 switch and configured VLAN interface 10
with a link-local and global IPv6 address 2001:DB8:1:10::1/64. The network administrator now
wants IPv6-capable endpoints connected to VLAN 10 to receive IPv6 addresses using stateless
autoconfiguration.
Which step must the network administrator complete on the 7500 switch?

View the Exhibit.

A network administrator configures VRRP on two HP 5800 switches, as shown in the exhibit.
VRRP settings not shown in the running-config are at their default settings. Which statement
accurately describes the VRRP group?