Refer to the exhibit.
All of the switches in the exhibit will route traffic across the switch-to-switch links. The company needs a
solution that converges quickly in case one or more of the links fail. Which routing solution meets the needs for
this use case?

Refer to the exhibit.The user on the left side of the exhibit wants to build a connection to the server on the right. Assume that
Switch A and Switch B are HP Comware switches and Switch B is a Layer 3 switch that is the default router for
VLANs 11 and 12. For which IP address does the user generate an ARP request?

Refer to the exhibit.
All of the switches are running Rapid Spanning Tree Protocol (RSTP). Link 1 fails. Switch 2 needs to select a
new root port and begins to send messages to Switch 3 and Switch 4. What happens?

When do the members in an existing Intelligent Resilient Framework (IRF) virtual device have a master
election?

Refer to the exhibit.
All of the switches in the exhibit are running Multiple Spanning Tree Protocol (MSTP). The ports that connect to
another switch are not boundary ports. All switches are configured as follows:• Config name = Region 1
• Revision number = 1
• Instance 1 =VLANs 10 and 12
• Instance 2 = VLANs 11 and 13
Currently, only VLANs 1, 10, 11, 12, and 13 exist on the four switches. A network administrator adds VLAN 15
to Switch_C. How is the topology affected by this change?

Refer to the exhibit.
Switch-1, an HP Comware switch, is connected to Switch-2, an HP ProVision switch on a link aggregation. The
exhibit shows the link aggregation status on both sides of the link. Based on the exhibit, what is the behavior
that the network administrator should expect?

Refer to the exhibit.
A network administrator has created an HP Intelligent Resilient Framework (IRF) device with two members.
The members are connected on two interfaces, which are assigned to one IRF port on each member. The
administrator enters the command shown in the exhibit.
What does the output indicate?

Refer to the exhibit.
What should the network administrator do to allow endpoints to receive IP addresses from the network DHCP
server?

A network administrator wants to discover an HP MultiService Mobility (MSM) AP in HP Intelligent Management
Center (IMC). The MSM AP is operating in autonomous mode. What should the administrator do to ensure that
IMC can discover the AP?

A network administrator has started configuring DHCP relay on an HP Comware switch with these commands:
[Switch] dhcp enable
[Switch] interface vlan 10
[Switch-Vlan-interface10] dhcp select relay
What else must the administrator do to finish configuring DHCP relay?