which parameters can be changed?
You are using Dynamic Optimization to tune a 3PAR virtual volume. In addition to radial placement
and drive type, which parameters can be changed? (Select Two)
Which characteristics are shared among all sibling SmartClones?
A SmartClone on a P4000 storage system shares a common parent volume with other SmartClones.
Which characteristics are shared among all sibling SmartClones? (Select two.)
Which replication protocol can fully utilize the pipe?
You have a 500MB/s link between sites that forms a 3PAR replication pair. Which replication
protocol can fully utilize the pipe?
What should you do?
You have just finished the installation of two P2000 G3 FC/iSCSI Arrays and your customer expresses
interest in being able to use Remote Snap Replication. What should you do?
What is most likely the cause?
All servers connected to your customer’s P4500 SAN are suddenly unable to write data to the
SAN. The servers can fulfill read request, but writes fails. What is most likely the cause?
How does data deduplication work?
How does data deduplication work?
Which factor could have a negative effect on backup performance?
You have a customer that has recently implemented a new backup system comprising of a
D2D4324 and Data Protector backup software. They are concerned as they are not experiencing
the backup throughput they were expecting.
Which factor could have a negative effect on backup performance?
Indicate which benefit is associated with each P6000 best practice.
HOTSPOT
Indicate which benefit is associated with each P6000 best practice.
Click the ESX virtual Switch configuration that provides the best overall performance for the environment̷
You are implementing a VMware ESX environment with a P4000 SAN. Click the ESX virtual
Switch configuration that provides the best overall performance for the environment and complies
with best practices.
which option should be selected to check the link between the systems?
When setting up a replication set using the Replication Wizard with the P2000 G3, which option
should be selected to check the link between the systems?