What must the network administrator do on interface Ten…
Refer to the exhibits.
Exhibit 1
Exhibit 2
The switch and server will transmit Fibre Channel over Ethernet (FCoE) traffic on the Ethernet link. If
congestion occurs, the devices should pause the FCoE transmissions rather than drop them. What must the
network administrator do on interface Ten-GigabitEthernet 1/0/2 to enable this behavior?
Which Comware configuration will allow the three VLANs …
An HP Provision switch has port A1 connected to port g1/0/1 of an HP Comware switch. The ProVision port has
the following configuration: vlan 1 untag A1 vlan 10 tag A1 vlan 20 tag A1
Which Comware configuration will allow the three VLANs to successfully pass traffic between the two switches?
What is a benefit of the HP Network Protector SDN Appli…
What is a benefit of the HP Network Protector SDN Application as opposed to a traditional IDS/IPS?
which view must an administrator access in order to exe…
On an HP Comware switch, which view must an administrator access in order to execute the debug command?
Which common data center requirement does an HP EVI sol…
Which common data center requirement does an HP EVI solution meet?
which ProVision command should the network administrato…
A customer has an HP ProVision switch capable of Layer 3 forwarding: however, Layer 3 forwarding is
disabled. The switch has an IP address in the management VLAN, where the default gateway is 10.1.1.1, which
ProVision command should the network administrator use so the ProVision switch can access the Intelligent
Management Center (IMC) server in a different VLAN?
What should the administrator do to accomplish this?
Refer to the exhibits on the Exhibit 1 and Exhibit 2 tabs.
Exhibit 1
Exhibit 2
Three HP switches are controlled by an HP VAN SDN Controller. The exhibits show the topology that the
controller has discovered for the switches and the port status on the 192.168.0.252 switch. All the interswitch
links carry the same VLANs.
The 192.168.0.249 switch and the 192.168.0.252 switch also connect on a link that is not shown in the
topology. The network administrator wants to make all of the links between the switches available for SDN
applications to use. What should the administrator do to accomplish this?
What is a valid reason to choose an 802.11a wireless im…
What is a valid reason to choose an 802.11a wireless implementation?
How does this zoning affect the FC fabric operation?
Refer to the exhibit.
The exhibit shows the Fibre Channel (FC) zones that are members of zonesets on an HP Comware switch.
How does this zoning affect the FC fabric operation?
Which method of link aggregation do both HP ProVision a…
Which method of link aggregation do both HP ProVision and Comware switches support?