What is a benefit of enabling tandem multicast replicat…
What is a benefit of enabling tandem multicast replication for SPBM?
which route to add to its IP routing table?
An HP switch learns identical valid routes with different protocols. How does the switch choose which route to
add to its IP routing table?
What is the correct port type and VLAN assignment for t…
Refer to the exhibits.
Exhibit 1
Exhibit 2
The switches shown in the exhibit are implementing SPBM. The network administrator is now setting up
interface Ten-GigabitEthernet1/0/1 to connect to a new VMware host. What is the correct port type and VLAN
assignment for the switch interface Ten-GigabitEthernet1/0/1?
which represents VLAN 30 in OSPF area 0?
Which ProVision configuration includes 10.0.3.0/24, which represents VLAN 30 in OSPF area 0?
What are two technologies that could be combined for th…
A company has a data center, which hosts production services, as well as development and quality assurance
services. The network infrastructure for all services should be isolated. The company also needs a highly
available, resilient large Layer 2 network for each set of services.
What are two technologies that could be combined for the data center Layer 2 solution?
What is the maximum number of active links supported be…
What is the maximum number of active links supported between a device and HP ProVision switches when
distributed trunking is used to connect the device to the ProVision switches?
What are correct peer statements for completing the con…
Refer to the exhibits.
Exhibit 1.
Exhibit 2
A network administrator is setting up a VPLS solution to connect sites 1, 2, and 3. Exhibit 2 shows part of the
configuration. What are correct peer statements for completing the configuration?
Which statement is true concerning spanning tree protoc…
Which statement is true concerning spanning tree protocols and HP switches?
What is a valid configuration?
An HP Comware switch has four MDCs defined on it. Network administrators need to set up SSH access to
each MDC and want to use the Management-Ethernet interface for that purpose. What is a valid configuration?
which of the following must you perform first?
When adding a new member to an existing IRF domain, which of the following must you perform first?