Which switch OpenFlow instance setting meets this requi…
A company has a team of HP VAN SDN Controllers. On several Comware switches, the network administrator
configures two controller IP addresses in the OpenFlow instance. The SDN application requires that the
switches perform the fastest failover from one controller to another.
Which switch OpenFlow instance setting meets this requirement?
What should the administrator do to accomplish this?
Refer to the exhibit.
The switches in the exhibit are all HP ProVision switches that run Multiple Spanning Tree Protocol (MSTP).
The network administrator wants all of the switch-to-switch links shown in the exhibit to be available for
forwarding routed traffic. What should the administrator do to accomplish this?
What must be corrected?
Refer to the exhibit.
A network administrator wants to use Application TLVs to communicate application priority information to a
Converged Network Adaptor (CNA). The administrator has configured the QoS policy shown in the exhibit for
this purpose and applied the policy outbound to the interface connected to the CAN. The solution is not working
correctly.
What must be corrected?
where should the administrator configure DHCP relay?
Refer to the exhibit.
The physical interfaces for Comware-1 and Comware-2 switches in the exhibit are configured in routed mode
and OSPF. Both switches have the three subnets in their routing tables. The administrator wants to use DHCP
to assign addressing information to the users. Based on the exhibit, where should the administrator configure
DHCP relay?
Which HP product meets these needs?
A customer requires greater visibility and insight into traffic flowing between virtual machines (VMs) on the
same ESXi host. Which HP product meets these needs?
What is correct about the domain and member IDs in this…
A network administrator configures several HP Comware switches to be part of a single Intelligent Resilient
Framework (IRF) virtual device. What is correct about the domain and member IDs in this configuration?
Which table will reject the go-to-table action in its flows?
A switch is configured with four OpenFlow tables: Table 0, Table 50, Table 100, and Table 200. Which table will
reject the go-to-table action in its flows?
How must the administrator configure a connected port o…
Refer to the exhibits.
Exhibit 1
Exhibit 2
A network administrator executes the show vlan commands and sees the output shown in the exhibits. How
must the administrator configure a connected port on an HP Comware switch?
Which HP solution meets the provider’s requirements?
A cloud service provider has multiple data centers. The provider wants to manage the complete multi-data
center environment and provision networking services for VMs in the cloud. The provider is looking for a
solution that automates configuration and integrates with cloud services.
Which HP solution meets the provider’s requirements?
which entry in the routing table would the switch use t…
Refer to the exhibit.
Examine the partial HP switch output shown in the exhibit. Based on this output, if the switch receives a packet
with a destination IP address of 10.2.90.87, which entry in the routing table would the switch use to forward thepacket?