You have entered the following command at the CLI of an HP E5400 zl Series switch.
Switch(vlan-1)# ip address 192.168.1.225/24
The switch’s other VLAN and IP parameters are at factory defaults. While testing this configuration, you find
that the switch cannot ping a server located at 192.168.2.22. You have confirmed the server is up and
available. This server is located in a data center not directly connected to your switch.
What must you configure on the switch to enable connectivity between these two devices?

Which A-Series switch is designed for the large data center and the enterprise core?

You must configure SSH on an HP A7500 switch. Whichitem must be generated on the switch?

You must configure a port on an A5800 switch to support protocol-based VLANs and port-based VLANs.
Which port type supports this requirement?

Refer to the Exhibit.

Which statement accurately describes the state of Gigabit Ethernet 3/0/12 in the HP A-Series switch
configuration shown in the exhibit?

You must configure VLANs and ports on an HP A7500 switch at default settings. What is the effect of the
following commands?
[SW-Gigabit-Ethernet1/0/1]port link-type trunk
[SW-Gigabit-Ethernet1/0/1]port trunk permit vlan 100 101

You have initiated a console session on an HP A-Series switch at default settings. What is your privilege level?

Which interface is available for managing A-Series switches at factory default settings?

You have uploaded an application file named “A12500.bin” to an HP A12500 switch. Which command ensures
this file is used during the next boot cycle?

Which view is indicated by the following prompt on an HP A7500 switch? <A7500>