which ProVision command should the network administrator use so the ProVision switch can access the Intelligen
A customer has an HP ProVision switch capable of Layer 3 forwarding: however, Layer 3
forwarding is disabled. The switch has an IP address in the management VLAN, where the default
gateway is 10.1.1.1, which ProVision command should the network administrator use so the
ProVision switch can access the Intelligent Management Center (IMC) server in a different VLAN?
which view must an administrator access in order to execute the debug command?
On an HP Comware switch, which view must an administrator access in order to execute the
debug command?
What can the administrator do that meets this requirement without disrupting the solution?
View the exhibit.
Exhibit 1
Exhibit 2
Area 1 and Area 2 in the topology are associated with/21 subnets, shown in Exhibit 1. All of the
switches in this topology are HP Provision ASIC switches, and they have established the
appropriate adjacencies.
In Area 1, one of the/24 subnets within the/21 range, 10.1.19.0/24, is not used. The network
administrator must prevent unnecessary traffic from entering Area 1 if users attempt to reach an
address in the unused range. What can the administrator do that meets this requirement without
disrupting the solution?
Which Comware configuration will allow the three VLANs to successfully pass traffic between the two switches?
An HP Provision switch has port A1 connected to port g1/0/1 of an HP Comware switch. The
ProVision port has the following configuration: vlan 1 untag A1 vlan 10 tag A1 vlan 20 tag A1
Which Comware configuration will allow the three VLANs to successfully pass traffic between the
two switches?
Which switch ports have the designated role in instance 1 when the MSTP network converges again?
View the exhibit.
In the example network shown in the exhibit, switch A loses power and becomes unavailable.
Which switch ports have the designated role in instance 1 when the MSTP network converges
again?
which of the following must you perform first?
When adding a new member to an existing IRF domain, which of the following must you perform
first?
what happens next?
View the exhibit.
Exhibit 1
Exhibit 2
An IRF device consists of four HP 5820 switches. The IRF topology is shown in Exhibit 1. The IRF
settings are shown in Exhibit 2. After these settings are displayed, Member 2 experiences a power
failure and shuts down. After an hour, power is restored, and Member 2 reboots.
Based on this event and the exhibits, what happens next?
Which statement is true concerning spanning tree protocols and HP switches?
Which statement is true concerning spanning tree protocols and HP switches?
What is the maximum number of active links supported between a device and HP ProVision switches when distribut
What is the maximum number of active links supported between a device and HP ProVision
switches when distributed trunking is used to connect the device to the ProVision switches?
How does the VRRP backup know if the VRRP master is available and functioning?
Two HP Provision switches are configured as virtual routers. How does the VRRP backup know if
the VRRP master is available and functioning?