How can a network administrator ensure that routing switch B uses the 10G link to reach 10.1.10.0/24 if its di
View the exhibit.
All switches in this figure are HP Provision ASIC switches. They are enabled to establish
adjacency with neighbors on all of their VLAN interfaces. Besides these configurations, they are
operating at the default OSPF settings.
How can a network administrator ensure that routing switch B uses the 10G link to reach
10.1.10.0/24 if its direct link to routing switch A fails?
Which parameter is enabled by default on an HP Commware switch, but disabled by default on an HP ProVision swi
Which parameter is enabled by default on an HP Commware switch, but disabled by default on an
HP ProVision switch?
which feature must be enabled first?
Before you enable dynamic IP lockdown on an 5400 zl switch, which feature must be enabled
first?
Which protocol is it?
A routing protocol has three characteristics:
Has fast convergence with triggered, incremental updates via link state advertisements (LSAs)
Is classless protocol allowing for a hierarchical design with VLSM and route summarization
Uses an intelligent metric (cost), which is the inverse of the bandwidth of an interface
Which protocol is it?
What is true about using EAP-Transport Layer Security (EAP-TLS) in the 802.1X process?
What is true about using EAP-Transport Layer Security (EAP-TLS) in the 802.1X process?
what is the corresponding term used for the Pre column in the Comware output shown in the exhibit?
Refer to the exhibit.
Exhibit: partial output of the HP Comware display ip routing command. Note the Pre or Preference column.
On an HP ProVision switch, what is the corresponding term used for the Pre column in the
Comware output shown in the exhibit?
Which HP ProVision switch command could a network administrator use to upgrade the operating system from an at
Which HP ProVision switch command could a network administrator use to upgrade the operating
system from an attached USB drive?
Which task should the administrator complete?
A network administrator wants to configure the precise MAC addresses that are allowed to send
traffic on a particular port on an HP 5400 zl Series switch. No other addresses can send traffic.
Which task should the administrator complete?
[Comware] interface loopback 2 [Comware-Loopback2] ip address 172.18.20.1 255.255.255.0 What is the problem wi
A network administrator attempts to create a loopback interface on an HP Comware switch, and it
fails. These are the commands the network administrator issues to do this.
[Comware] interface loopback 2
[Comware-Loopback2] ip address 172.18.20.1 255.255.255.0
What is the problem with the proposed configuration/
Which statement accurately describes how network administrators can apply routed access control lists (RACLs)
Which statement accurately describes how network administrators can apply routed access
control lists (RACLs) or VPN access control lists (VACLs) on an HP 8200 zl switch?