Which common data center requirement does an HP EVI solution meet?

What is a benefit of the HP Network Protector SDN Application as opposed to a traditional IDS/IPS?

Refer to the exhibits.
Exhibit 1

Exhibit 2

The switch and server will transmit Fibre Channel over Ethernet (FCoE) traffic on the Ethernet link. If
congestion occurs, the devices should pause the FCoE transmissions rather than drop them. What must
the network administrator do on interface Ten-GigabitEthernet 1/0/2 to enable this behavior?

An HP Comware switch has four MDCs defined on it. Network administrators need to set up SSH access to
each MDC and want to use the Management-Ethernet interface for that purpose. What is a valid
configuration?

Refer to the exhibits.
Exhibit 1

Exhibit 2

A network administrator is setting up a VPLS solution to connect sites 1, 2, and 3. Exhibit 2 shows part of
the configuration. What are correct peer statements for completing the configuration?A. PE-1: peer 10.1.1.3 pw-id 1001PE-2: peer 10.1.1.1 pw-id 1001PE-3: peer 10.1.1.2 pw-id 1002

A company has a data center, which hosts production services, as well as development and quality
assurance services. The network infrastructure for all services should be isolated. The company also needs
a highly available, resilient large Layer 2 network for each set of services.
What are two technologies that could be combined for the data center Layer 2 solution?

Refer to the exhibits.
Exhibit 1

Exhibit 2

The switches shown in the exhibit are implementing SPBM. The network administrator is now setting up
interface Ten-GigabitEthernet1/0/1 to connect to a new VMware host. What is the correct port type and
VLAN assignment for the switch interface Ten-GigabitEthernet1/0/1?

What is a benefit of enabling tandem multicast replication for SPBM?

A customer has an existing network that includes HP Comware switches. The company wants to begin
implementing SDN using the HP VAN SDN Controller. How does the company ensure that it meets the
requirements for the solution at the SDN infrastructure layer?

Refer to the exhibit.

Assume that the switches in the MPLS region are correctly configured with OSPF, MPLS, and LDP. They
are using liberal retention mode for labels.
The network administrator wants LSP convergence to occur as quickly as possible in case one of the
redundant links fails. What should the administrator do on each MPLS switch?