Refer to the exhibit.
The exhibit shows how two NICs on a physical server connect to two HP 5820 switches. The
server supports eight virtual machines (VMs) with VMware version 5.1. The VMware standard
virtual switch is bound to NIC and NIC2. This switch implements source MAC load balancing for
the NIC team.
What is the proper configuration for ports 1/0/1 and 2/0/1?
A.
Place the ports in a bridge aggregation group that does not use LACP
B.
Place the ports in a bridge aggregation group that uses LACP
C.
Enable LACP on the individual ports
D.
Do not place the ports in a bridge aggregation group
A
0
0
Answer: C
0
0
Albert and Murat, you mostly commented on all the questions, i am applying for this exam in one week, and i am depending on actual test for that. some of your answers match the actual test and some not 🙁 i am confused now.
for example for this question, actual test says it is B !
0
0
i think answer is A
vmware standard vSwitch does not support LACP
“Note: LACP is only supported in vSphere 5.1 and 5.5, using vSphere Distributed Switches (VDS) or the Cisco Nexus 1000v.”
these switches are in IRF so port can be in LAG and use for load balancing
0
0
This is pulled right out of the study guide, figure 10-15.
VMware standard virtual switches do NOT support LACP, so B and C are out.
This type of setup requires aggregation, so D cannot be correct. The only possible answer is A.
0
0
A. according to exam prep guide (question 29 in the end)
0
0