An administrator logs into the vSphere Web Client, but is unable to see any hosts and clusters.
Which two options could fix the problem? (Choose two.)

An administrator is attempting to remove an ESXi 6.x host from a vSphere Distributed Switch (vDS). When the administrator attempts to remove the host, the
following error is observed:
The resource ’16’ is still in use.
What three steps are needed to successfully remove the host from the switch? (Choose three.)

An administrator has been tasked with enabling High Availability (HA) on a cluster in a vSphere 6.x environment with default settings. The cluster configures
properly and there are no errors. The next day when powering on a virtual machine, an error is presented:
Not Enough Failover Resources
Which three scenarios are likely causes of this error message? (Choose three.)

An administrator is using the Host Failures to Tolerate Admission Control Policy for a vSphere High Availability (HA) cluster. When configuring this setting on the
cluster, the administrator sees this error message:
Insufficient resources to satisfy HA failover level on cluster
What are two likely causes for the error? (Choose two.)

An administrator is installing a new network card in an ESXi 6.x host that is part of a vSphere cluster. When the host is placed into maintenance mode, the vSphere
Web Client displays the progress bar at 2% for over 30 minutes.
Which two are likely reasons for this occurrence? (Choose two.)

An administrator is monitoring a High Availability (HA) and Distributed Resource Scheduler (DRS) enabled cluster and has noticed that virtual machines in the
cluster are being migrated without user intervention.
Why is this happening?

Refer to the Exhibit.

A storage administrator is not seeing full utilization of all bandwidth from an ESXi host. The vSphere administrator observes the adapter details, as shown in the
Exhibit.
What is the probable cause of this issue?

Refer to the Exhibit.

An administrator has been given requirements to configure vMotion for a new virtual machine. The configuration should:
Provide Network Redundancy
Use VLAN 550
Be secured against anyone trying to spoof communication
The vSwitch1 configuration is shown in the Exhibit.
Which three changes should be made to meet the stated requirements? (Choose three.)

When attempting to power on a Virtual Machine you observe the following error:

Cannot open the disk ‘/vmfs/volumes/volume/vm/vm-000002.vmdk’ or one of the snapshot disks it depends on.
Which three actions will be the best solutions to address this problem? (Choose three.)

A physical Windows 2008 R2 Server is converted to a virtual machine using VMware vCenter Converter. Upon completion of the conversion and subsequent power
on operation, the virtual machine fails to boot and the message below is observed in the Console of the virtual machine:
STOP 0x0000007B INACCESSIBLE_BOOT_DEVICE
Which two potential issues may be causing this boot failure? (Choose two.)