what is a portset bound to?
In Data ONTAP 7.3, what is a portset bound to?
What is the number of paths for ten LUNs on a single host with one connection to each fabric?
A dual controller FAS3100 series is connected to a dual fabric with two active target ports
per fabric in a singleimage cfmode, and uses a single portset. What is the number of paths
for ten LUNs on a single host with one connection to each fabric?
What are two performance tuning parameters available for Fibre Channel HBAs on a host?
What are two performance tuning parameters available for Fibre Channel HBAs on a host?
(Choose two.)
What are two reasons why this is possible?
During an equipment move a Fibre Channel cable from a host to a switch is accidentally
plugged into a different switch port on the FC switch. However, the host still sees the storage
devices on all its paths. What are two reasons why this is possible? (Choose two.)
What is mandatory for you to configure?
You connect a host to a NetApp storage system through an FC switch. The host has its boot
volumes on the NetApp storage system. What is mandatory for you to configure?
Which file should the administrator check for SAN connectivity errors?
A Solaris administrator just noticed that a host has lost connectivity to the company SAN.
Which file should the administrator check for SAN connectivity errors?
Which NetApp host utility command determines the number of paths per LUN visible to the host?
Which NetApp host utility command determines the number of paths per LUN visible to the
host?
how will the I/O fail over?
You have a Windows 2003 host using the NetApp ONTAP DSM MPIO environment with a
FAS6000 high availability configuration running single image cfmode. When you disconnect
a cable from the FC switch to a storage target port, how will the I/O fail over?
which ports will be considered active by VERITAS DMP using the NetApp ASL to a LUN on controller 1 mapped to h
A Solaris 10 host with VERITAS Storage Foundation 4.1 is FCP attached to a FAS3140 high
availability storage system running single image cfmode. Using the diagram shown, which
ports will be considered active by VERITAS DMP using the NetApp ASL to a LUN on
controller 1 mapped to host 1?
Which host-based tool will enable you to stripe a LUN across multiple NetApp controllers?
Which host-based tool will enable you to stripe a LUN across multiple NetApp controllers?