To create a 64-bit aggregate, which optional switch/flag/parameter/option to the aggr create
command must be included?

After upgrading to DOT 8.0 7-mode, you can convert existing 32-bit aggregates into 64-bit
aggregates.

With 64-bit aggregates, the number of FlexVols that can be created on a storage controller is
____.

The largest volume that can be created on a 64-bit aggregate is ___.

Which command will show the FCP target(s) on a storage system?

You are having problems accessing three recently-created LUNs. Given the output below,
the reason is because all of the LUNs are using the same LUN ID of 0.
lun show -m
LUN pathMapped to LUNID
—————————————————
/vol/vol1/lun0 solaris-igroup0 0
/vol/vol1/lun1 windows-igroup 0
/vol/vol1/qtree1/lun2 aix-igroup 0
/vol/vol1/qtree1/lun3 linux-igroup 0

Using the output below, a co-worker determined that these are type “Solaris” LUNs. What
would your determination be?
lun show -m
LUN pathMapped to LUN ID
—————————————————
/vol/vol1/lun0 solaris-igroup0 0
/vol/vol1/lun1 solaris-igroup1 0
/vol/vol1/qtree1/lun2 solaris-igroup2 0
/vol/vol1/qtree1/lun3 solaris-igroup3 0

Which two commands would help you troubleshoot a LUN that cannot be accessed by a
host? (Choose two.)

NetApp recommends that Fibre Channel switches that have both disk and tape connected to
them should have separate zones created for each.

Which command shares out the directory /vol/vol2/home using the share name “netapp”?