Which ONTAP LUN parameter will keep the LUN online when…
Your host supports SCSI T10 thin provisioning for automatic host-side space management, and it enabled.
Which ONTAP LUN parameter will keep the LUN online when it is full?
which design solution is shown?
Which two actions will help determine the problem?
You have a host that loses connectivity to a LUN after a volume is moved from one node to another node in the
cluster. You verified that you do not have a problem with the cluster, a switch, or reporting nodes.
Which two actions will help determine the problem? (Choose two.)
which IP address should be used to accomplish this task?
which combination is valid?
To provide host connectivity for both SAN and NAS protocols, which combination is valid?
What must you do to solve the problem?
Your vSphere administrator asked you to create an additional 5GB boot LUN for their new ESX1 installation. To
complete this request, you have entered the following CLI commands:
lun create –vserver svm1 -volume boot -lun exsi_1 -size 5G -ostype vmware igroup
create – vserver svm1 -igroup esxi_1 -protocol fcp -ostype vmware –initiator
50:01:43:80:05:68:5f: B6
However, the vSphere administrator has reported that they are unable to see the newly configured LUN.
What must you do to solve the problem?
What are two important considerations when issuing the …
What are two important considerations when issuing the lun move start command? (Choose two.)
which two network settings should you configure to opti…
You are deploying iSCSI on a newly installed ON TAP cluster. Your network administrator has provided you
with 10 Gb network links and physically connected them to your nodes.
According to NetApp best practice, which two network settings should you configure to optimize performance?
(Choose two.)
Which statement is correct in this scenario?
You want to ensure maximum performance of iSCSI LUNs.
Which statement is correct in this scenario?
Which statement about this command is true?
You are asked to configure the Service Processor on a newly installed node, and must verify the following
command:
system-service processor network modify –node local –address-family IPv4 –enable
true -ip-address 192.168.123.98 –netmask 255.255.255.0
Which statement about this command is true?