On an MX Series device, you must enable routing between VLANs 100,200, and the Internet ge-5/1/0, and ge-5/1/2 are bundled into interface ae3. Ge-5/1/4, and ge-5/1/5 are bundles into interface ae2. Both AE bundles trunk VLANs 100 and 200.
In this scenario, what is the correct configuration snippet for VLAN 100?
A.
interfaces {
xe-2/1/0 {
unit 0{
family inter {
address 10.0.10.2/24;
}}
}
irb {
unit 0{
family inet {address 10.0.1.2/24;
}}
unit 1 family inet {
address 10.0.2.2/24;
}}}}
bridge-domains {
vlan-100{
domain-type bridge;
vlan-id 100;
interface ge-2/2/2.100;
interface ae1.100;
interface ae3.100;
routing-interface irb.0;
}}
B.
interfaces {
xe-2/1/0{
unit 0{
family inet {
address 10.0.10.2/24;
}}}
ip-0/0/0{
unit 0{
family inet {
address 10.0.1.2/24;
}}
unit 1{
family inet {
address 10.0.2.2/24;
}}}}
bridge-domains {
vlan-100{
domain-type bridge;
vlan-id 100;
interface ge-2/2/2.100;
interface ae1.100;
interface ae3.100;
interface ip-0/0/0.0;
}}
C.
interfaces {
xe-2/1/0 {
unit 0 {
family inet {
address 10.0.10.2/24;
}}}
irb {
unit 0{family inet {
address 10.0.1.2/24:
}}
unit 1 {
family inet {
address 10.0.2.2/24;
}}}}
bridge-domains {
vlan-100{
domain-type bridge;
vlan-id 100;
interface ge-2/2/2.100;
interface ae1.100;
interface ae3.100;
}}
D.
interfaces {
xe-2/1/0 {
unit 0{
family inet {
address 10.0.10.2/24;
}}}
ip-0/0/0 {
unit 0 {
family inet {
address 10.0.1.2/24;
}}
unit 1 {
family inet {
address 10.0.2.2/24;
}}}}
bridge-domains {
vlan-100{
domain-type bridge;
vlan-id 100;
interface ge-2/2/2.100;
interface xe-2/1/0.0;
interface ae1.100;
interface ae3.100
interface ip-0/0/0.0;
}}