Refer to the Exhibit.

As shown in the exhibit, the 10.10/16 prefix is redistributed into OSPF through R2 and R5. R2 and R5 are advertising the prefix with a Type 2 metric of 100.What is the preferred path to reach 10.10/16 from R6?

Refer to the Exhibit.

In the exhibit, Source is sending multicast traffic to the multicast group address ffbe::1.Which protocol must you configure on R1’s ge-0/0/0 to forward multicast traffic toward the receiver?

You notice that a number of IGMP leave group messages are passing through a BMA network and are impacting the network’s performance. What would you do to resolve this issue without affecting multicast traffic?

R1 has an OSPF adjacency with R2 over a point-to-point link. Which three statements about the advertisements for this link in the Type 1 (Router) LSA generated by R1 are true? (Choose three.)

Refer to the Exhibit.

Looking at the output in the exhibit, why is the BGP neighbor not in Established state?

Refer to the Exhibit.

You are attaching into an EX Series switch-1a legacy IP phone that does not support LLDP-MED, but does allow configuration using DHCP, as shown in the exhibit. Your existing network QoS policies dictate that VoIP traffic must traverse over VLAN 10.Which two actions put VoIP traffic onto VLAN 10? (Choose two.)

Refer to the Exhibit.

In the exhibit, which statement about the ABR between Area 8 and Area 2 is true?

What is the default LLDP timeout?

Refer to the Exhibit.

Based on the output shown in the exhibit, which protocol is configured?

Refer to the Exhibit.

Referring to the output in the exhibit, why does the router prefer the path toward interface ge- 0/0/0.0 for the 20.0.0.0/8 route?