Which configuration parameter is missing from your PE router configuration?
Click the Exhibit button.
In the exhibit, your Layer 3 VPN uses BGP to send and receive routes from customers. Customer
A reports that remote routes are not being received on CE2.Which configuration parameter is
missing from your PE router configuration?
Which two steps ensure that traffic to the provider flows through R2 while the network is working properly?
Click the Exhibit button.
In the exhibit, R1 and R2 have a static default route configured that points toward the provider.
Both routers redistribute the default route into OSPF. R2 is the preferred gateway to reach the
provider. R1 is the backup gateway. All link metrics are equal. Which two steps ensure that traffic
to the provider flows through R2 while the network is working properly? (Choose two.)
which statement is correct?
Click the Exhibit button.
On your MX Series router, traffic using the voice scheduler has exceeded its transmit rate. All
other data is currently in profile. Referring to the exhibit, which statement is correct?
Which two statements are true?
Click the Exhibit button.
In the exhibit, R1 has a loopback address of 192.168.1.1. Its loopback interface is included in
OSPF Area 1.Which two statements are true? (Choose two.)
Which Layer 2 VPN configuration is correct for PE2?
Click the Exhibit button.
You are provisioning a full-mesh BGP Layer 2 VPN for Customer A. The customer has four remote
sites in their network. Using best practices, you assigned interface unit numbers matching the
assigned VLAN numbers. Which Layer 2 VPN configuration is correct for PE2?
Which statement is true about IS-IS?
Which statement is true about IS-IS?
Which three steps will accomplish this task?
Click the Exhibit button.
In the exhibit, network 172.16.0.0/16 is redistributed into IS-IS in Area 49.0002. R1 must use R2 to
access 172.16.0.0/16. All other traffic leaving Area 49.0001 must use R4.Which three steps will
accomplish this task? (Choose three.)
which statement is correct?
Click the Exhibit button.
Based on the output in the exhibit, which statement is correct?
what is the problem?
Click the Exhibit button.
Customer A is complaining that routes advertised from the CE2 router are not being received on
the CE1 router. The physical topology of the network is CE1-PE1-PE2-CE2. The CE1-PE1 subnet
is 172.16.1.0/24. The CE2-PE2 subnet is 172.16.2.0/24. PE1’s loopback is 192.168.3.1 and PE2’s
loopback is 192.168.4.1.Referring to the output in the exhibit, what is the problem?
Which statement is true?
Click the Exhibit button.
In the exhibit, all routers within each AS are configured for Anycast RP. All intra-AS routers are
configured within the same MSDP mesh group. Inter-AS multicast has been enabled using MSDP
without MSDP mesh groups. Which statement is true?