You have two OSPF routers that are trying to form an adjacency. When you issue the command
show ospf neighbor, you see that one router is in the loading state and the other is in the full state.
Why are you seeing the router’s state as loading?

Which two events could cause the BGP Active state to appear? (Choose two.)

The policy shown in the exhibit has been configured and installed on your router.
What is the result of applying this policy?

Which type of router can provide connectivity between areas in an IS-IS domain?

You have been asked to provision a service provider’s network to accommodate Layer 3 VPNs as
defined in RFC 4364. Which three tasks must be performed before the provider network is ready
to carry VPN traffic? (Choose three.)

By default, which BGP attribute is only compared when two route advertisements are received
from the same neighboring AS?

Referring to the exhibit, what must be true of the vlan_100 bridge domain?

An Ethernet bridge is configured such that all interfaces are in a single broadcast domain. Which
two tasks does the bridge perform in response to receiving a frame with an unknown unicast
destination MAC address? (Choose two.)

You have configured multiple IP-IP tunnels across your network to provide connectivity to remote
sites. Which technique is used to help the IP endpoints in your network determine the optimal
packet size to send across your tunnels?

You have configured an RSVP LSP in your network and have assigned it one primary and two
secondary paths.
Which command is used to validate that the LSP is using the primary path?