How does an administrator block IGMP reports for the 239.0.0.0/8 group range?

Refer to the Exhibit.

In the exhibit, Source is sending multicast traffic to the multicast group address ffbe::1.Which
protocol must you configure on R1’s ge-0/0/0 to forward multicast traffic toward the receiver?

Which AS path regular expression will only match a route originating in AS 500 with the last
traversing AS of 100?

Refer to the Exhibit.

As shown in the exhibit, the 10.10/16 prefix is redistributed into OSPF through R2 and R5. R2 and
R5 are advertising the prefix with a Type 2 metric of 100.What is the preferred path to reach
10.10/16 from R6?

Refer to the Exhibit.

Looking at the trace options output in the exhibit, why are the OSPF routers stuck in Init state?

Which two statements about MVRP on EX Series switches are true? (Choose two.)

Your customer has five office locations. Each office location has 20 VLANs configured, one for
each department. Your engineering team has recently secured a government contract with strict
regulations which require that engineers be placed into separate workgroups. These workgroups
cannot communicate with each other. Without changing the primary VLAN assignments, which
JUNOS feature meets this requirement with minimal configuration?

Refer to the Exhibit.

In the exhibit, switches S1, S2, and S3 have Q-in-Q tunneling configured between Site 1 and Site
2.Which configuration on switch S1 allows Site 1 and Site 2 to exchange Cisco Discovery Protocol
(CDP), but blocks VLAN Trunking Protocol (VTP) between Site 1 and Site 2?

A coffee shop offering free Internet service to customers wants to implement the following security
policies:
1. Every customer must agree to a set of terms and conditions before accessing the Internet.
2. Log out customers that are logged in for more than one hour.
3. Log out customers that are idle for more than 5 minutes.
4. Authenticate employee desktop computers with known hardware addresses in the office of the
coffee shop to access the Internet without the above restrictions.

The following configuration has been applied to the switch:
set access radius-server 172.16.14.26 port 1812
set access radius-server 172.16.14.26 secret Am@zingC00f33
set access profile dot1x authentication-order radius
set access profile dot1x radius authentication-server 172.27.14.226
What would you add to implement these policies?

Refer to the Exhibit.

In the PIM-SM network in the exhibit, all links in the topology have the same IGP metric
configured.
Which link will not be on the RPT?