Refer to the Exhibit.

Referring to the exhibit, a packet sent from User A to User B will be forwarded out interface 0/0/23
using which source MAC address?

Refer to the Exhibit.

If all OSPF routers shown in the exhibit boot at the same time, which router will be elected as the
designated router?

Refer to the Exhibit.

Referring to the exhibit, a packet destined to 172.129.3.5 is sent from ISP X towards R1.
Which statement describes how R1 handles the packet?

Refer to the Exhibit.

Referring to the exhibit, note that R5 is exporting the 172.168.1.0/24 route into OSPF. Which LSA
type does R2 send to R4?

Refer to the Exhibit.

Referring to the exhibit, R1, R2, and R3 boot at the same time. Several minutes later, R4 boots.
After R4 has been online for 40 seconds, which router will be the OSPF designated router?

Refer to the Exhibit.
— Exhibit –routing-options {

router-id 10.10.1.2;
}
policy-options {
policy-statement loadbalance {
term 1 {
from {
route-filter 100.100.0.0/16 exact;
}
then {
load-balance per-packet;
}
}
}
}
Referring to the exhibit, you have configured a load balancing policy and the router has an equal
cost path for traffic to 10.100.0.0/16.
What must you do to complete the load balancing configuration?

Refer to the Exhibit.

All OSPF routers shown in the exhibit booted at the same time, and the network has stabilized.
How many adjacencies does R1 have?

Refer to the Exhibit.

You have two routers, R1 and R2, running OSPF in area 0. Router R1 is having problems with
forming and adjacency with Router R2.
Referring to the exhibit, which statement is correct about the OSPF configuration in the Router R1
trace output?

Refer to the Exhibit.
— Exhibit –user@Switch-1# run show dhcp snooping binding
DHCP Snooping Information:
MAC address IP address Lease (seconds) Type VLAN Interface
00:26:88:02:74:89 172.28.1.4 – static default ge-0/0/9.0
00:26:88:02:74:86 172.28.1.2 86113 dynamic default ge-0/0/6.0
00:26:88:02:74:87 172.28.1.3 86378 dynamic default ge-0/0/7.0
— Exhibit –DHCP snooping is implemented on an EX Series switch. The results display a static MAC to IP
binding on interface ge-0/0/9 as shown in the exhibit.
Which statement is correct?

Refer to the Exhibit.
— Exhibit –policy-statement load-balance {
from {
route-filter 172.24.0.0/24 exact;
route-filter 172.24.1.0/24 exact;
}
then {
load-balance per-packet;
}
}
— Exhibit –Referring to the exhibit, which command or set of commands completes the configuration that will
load balance packets to destinations 172.24.0.0 and 172.24.0.1?