Refer to the Exhibit.

Devices S1 and S2 have the interface configurations as shown in the exhibit. You attach ge-0/0/0
on S1 to ge-0/0/0 on S2. You attach ge-0/0/1 on S1 to ge-1/0/20 on S2. However, the ae0
interface remains down on both S1 and S2. What should you change to cause the ae0 interface to
come up?

You want to configure a redundant trunk group on a switch. You want ge-0/0/0.0 to be the default
link; however, if ge-0/0/0.0 fails and the switch begins using ge-0/0/1.0, you want the switch to
continue using ge-0/0/1.0 until ge-0/0/1.0 fails. Which configuration will accomplish this scenario?

Which three steps must you complete for an aggregated Ethernet configuration on a switch?
(Choose three.)

You are using redundant trunk groups (RTG) on your network.
Which two statements accurately describe RTG? (Choose two.)

Which two packet types are handled solely by the RE within an EX4200? (Choose two.)

Which statement is correct regarding the VLAN factory-default configuration on an EX Series

switch?

Under which hierarchy do you configure OSPF?

You add a GRE tunnel to transport packets between two routers. After implementing this, you
notice an increase in the number of dropped packets. While looking at packet captures, you notice
that the do-not-fragment (DF) bit is set in the IP header of all the dropped packets.
What would cause this changed behavior?

Which three statements are correct about a Junos firewall filter? (Choose three.)

Which type of port must be an 802.1Q tagged port?