Which three actions are valid methods to clear all entries from the Ethernet switching table on an
EX Series switch? (Choose three.)

You are viewing the output of the operational-mode command show interfaces ge-0/0/4 on an EX
Series switch in which no ether-options are configured for the ge-0/0/4 interface. Which two default
settings are listed in the output? (Choose two.)

You must route both IPv4 and IPv6 packets in your environment. Which configuration should you
add at the [edit protocols] level to allow you to accomplish this objective?

Refer to the Exhibit.

In the exhibit, you run the command show ospf neighbor on R3 and notice that an adjacency with
R5 remains in the 2-Way state. Which statement is true?

You see a route in your local routing table that was learned using OSPF. Which command allows
you to determine where the route originated?

Which two events trigger an IS-IS LSP to be sent to a neighboring IS? (Choose two)

What does the attach bit in an IS-IS PDU indicate?

On a broadcast network, which three statements are true about IS-IS adjacencies? (Choose
three.)

Which two prerequisites does IS-IS need to operate? (Choose two.)

You configure a metric of 200 on an IS-IS enabled interface on Router-1. When you examine the
routing table entry for that link on another IS-IS device, you see a metric of 67. What would explain
this behavior?