Refer to the Exhibit.

After adding Customer C to your Layer 3 VPN, you must validate that PE2 is receiving VPN routes
for all customers attached to PE1, as shown in the exhibit. Which operational command displays
this information?

You are adding nonforwarding route reflectors to your network. Which three actions ensure that
VPN routes are advertised properly? (Choose three.)

Refer to the Exhibit.

Referring to the exhibit, Customer A is complaining that no OSPF routes are being received
across your Layer 3 VPN. You suspect that a problem exists with the PE-CE protocol. The core
network is operational. Which operational command on PE1 helps troubleshoot this problem?

Refer to the Exhibit.

Based on the topology shown in the exhibit, which two configuration statements must be applied
on R2 so that it announces the 10.100/22 network to its OSPF neighbors? (Choose two.)

Refer to the Exhibit.

Based on the configuration shown in the exhibit, which two statements are correct? (Choose two.)

Refer to the Exhibit.

The IGP is IS-IS. R2 has configured its loopback interface in Level 2 only. Referring to the exhibit,
which statement is true?

Refer to the Exhibit.

Using the configuration and topology in the exhibit, which statement is true?

Refer to the Exhibit.

Based on the output in the exhibit, which statement is correct?

Refer to the Exhibit.

You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across
both available links for all routes to ISP B’s network. You start by configuring this policy:
policy-statement load-balance {
then {
load-balance per-packet;
}
}
Which two commands do you use to finish the configuration? (Choose two.)

Refer to the Exhibit.

Based on the output shown in the exhibit, what does up signify?