Router R5 has the overload parameter configured. Which statement is true?

What is a limitation of LDP?

Refer to the Exhibit.

You work for ISP A. Customers of both ISP B and ISP C must be able to reach all of your
customers, but your network must not allow transit traffic between ISP B and ISP C.
Referring to the exhibit, which two methods could you use? (Choose two.)

Refer to the Exhibit.

In the exhibit, Area 1 and Area 2 are configured as not-so-stubby areas. RIP network
192.168.100.0/24 is redistributed into OSPF in Area 1.Which three statements are true? (Choose
three.)

Refer to the Exhibit.

Referring to the exhibit, your network management systems have alerted you to a loss of
connectivity to the CE2 router in your Layer 3 VPN. The loopback address of the CE router is
10.10.1.1/32.Which operational command on PE2 verifies connectivity across the PE-CE link?

Refer to the Exhibit.

You are configuring a new PE router in your Layer 3 VPN. A remote PE router is using the
configuration shown in the exhibit. Which configuration is needed to receive customer-vpn routes
from the remote PE?

Refer to the Exhibit.

Based on the output in the exhibit, which statement is correct?

Which two statements describe advantages of using BGP for VPLS signaling instead of LDP
signaling? (Choose two.)

Refer to the Exhibit.

A LDP Layer 2 circuit is shown for VPN A and VPN B. LDP tunneling over RSVP is activated on
P1 and P2. Referring to the exhibit, which statement is true about the LDP Layer 2 circuit?

Refer to the Exhibit.

Customer A is complaining that CE1 and CE2 cannot form an OSPF adjacency across your LDP
Layer 2 circuit. The physical topology of the network is CE1-PE1-P-PE2-CE2. PE1’s loopback is
192.168.5.1, P’s loopback is 192.168.6.1, and PE2’s loopback is 192.168.7.1.
Referring to the output in the exhibit, what is the problem?