Which set of BGP attributes is preferred by the Junos OS?

Which three statements are true regarding BGP peers? (Choose three.)

What is the correct sequence of the BGP route selection process?

Your ISP reports that you are being sent a route prefix but you cannot see it in your routing table.
Which two commands will help? (Choose two.)

— Exhibit —
[edit]
user@router# commit
[edit protocols]

‘bgp’
Error in neighbor 172.27.1.4 of group ebgp:
must define local autonomous system when enabling BGP
error: configuration check-out failed
— Exhibit —
You are configuring BGP on a new router. While attempting to commit the configuration, you
receive the error shown in the exhibit.
What must be done to allow the commit to complete?

— Exhibit –

— Exhibit —
You recently configured a new EBGP peering from R1 to your ISP. You are asked to determine
which BGP routes are being advertised from R1 to this new EBGP neighbor.
Referring to the exhibit, which command is used to verify this information on R1?

You must verify whether the prefix 172.28.102.0/24 has been advertised by BGP peer 172.18.1.1
and accepted into the routing table.
Which command would you use to accomplish this task?

Prefix 172.28.102.0/24 has been advertised by BGP peer 172.18.1.1. You must verify that it has
been received by your Junos device before a policy has been applied.
Which command would you use?

You are asked to identify a tunneling solution between two remote sites and are considering GRE
and IP-IP tunnels to meet the requirement.
Which two statements describe the differences between the proposed solutions? (Choose two.)

You are asked to deploy a GRE tunnel between two remote sites.
Which two statements are correct? (Choose two.)