Which function does Diffie-Hellman exchange perform for IPsec VPN?
Which function does Diffie-Hellman exchange perform for IPsec VPN?
which command would you use to add an additional address to the ge-0/0/9.0 interface?
interfaces {
ge-0/0/8 {
unit 0 {
family inet {
address 192.168.1.1/24;
}}}
ge-0/0/9 {
unit 0 {
family inet {
address 192.168.10.1/24;
}}}}
Referring to the exhibit, which command would you use to add an additional address to the
ge-0/0/9.0 interface?
which two routing information sources can you change the default preference value?
You are modifying the default route preference under the [edit protocols] hierarchy.
In which two routing information sources can you change the default preference value? (Choose
two.)
which two statements are correct about IPsec configuration?
Referring to the exhibit, which two statements are correct about IPsec configuration?
(choose two)
which next-hop IP address will be used for the destination IP address 192.168.1.142?
user@router> show route protocol static
inet.0: 12 destinations, 12 routes (12 active, 0 holddown, 0 hidden)
+ = Active Route, – = Last Active, * = Both
192.168.1.128/27 *[Static/5] 00:03:13
> to 10.20.106.10 via fe-0/0/5.106
192.168.1.144/29 *[Static/5] 00:03:13
> to 10.20.14.131 via ge-0/0/0.0
192.168.1.192/27 *[Static/5] 00:03:13
> to 10.18.1.1 via ge-0/0/1.0
192.168.1.128/28 *[Static/5] 00:01:06
> to 10.20.14.130 via ge-0/0/0.0
Given the routing entries shown in the exhibit, which next-hop IP address will be used for the
destination IP address 192.168.1.142? (Assume that only static routes are available for the
destination.)
which action will the router take?
By default, if equal-cost paths exist for the same destination, which action will the router take?
Which three components can be downloaded and installed directly from Juniper Networks update server to an SRX
Which three components can be downloaded and installed directly from Juniper Networks
update server to an SRX Series device? (Choose three.)
Which step should be taken to solve the problem?
user@router# run show interfaces terse
Interface Admin Link Proto Local
fe-0/0/0 up up
fe-0/0/0.0 up up inet 10.0.39.2/24
iso
mpls
fe-0/0/1 up up
fe-0/0/1.0 up up inet 10.0.18.2/24
fe-0/0/1.513 down up inet 10.0.19.2/24
An administrator is unable to ping any address on the 10.0.19.0/24 subnet. To identify the
problem, the administrator uses the command shown in the exhibit.
Which step should be taken to solve the problem?
Which command will display only direct routes?
Which command will display only direct routes?
What are two explanations for this behavior?
You have a chassis cluster established between two SRX Series devices. You re monitoring
the status of the cluster and notice that some redundancy groups show disabled.
What are two explanations for this behavior? (choose two)