what are two differences between the active and candidate configurations?
[edit]
user@router# show | compare
[edit protocols ospf area 0.0.0.0]
– interface ge-0/0/0.0 {
– disable;
– }
[edit protocols ospf]
area 0.0.0.0 { … }
+ area 0.0.0.1 {
+ interface ge-0/0/0.0;
+ }
Referring to the exhibit, what are two differences between the active and candidate
configurations? (Choose two.)
Which configuration command accomplishes this goal?
You would like to configure your PC’s IP address of 10.10.0.156 as an FTP host with a username
of user and a password of mypass. Which configuration command accomplishes this goal?
Which control expression must be the last line in all macros?
Which control expression must be the last line in all macros?
how often does an ERX Edge Router send an OSPF link-state advertisement in a stable network?
By default, how often does an ERX Edge Router send an OSPF link-state advertisement in a stable
network?
Which two parameters are virtual router specific?
Which two parameters are virtual router specific? (Choose two.)
Which mode is used to allow only a single person to edit a configuration?
Which mode is used to allow only a single person to edit a configuration?
Which two types of dynamic interfaces result from this configuration?
A configuration profile contains the following commands: pppoe sessions 2 ppp authentication chap
ip access-routes Which two types of dynamic interfaces result from this configuration? (Choose two.)
Which two external authentication server types are supported by JUNOS Software for firewall user authenticatio
Which two external authentication server types are supported by JUNOS Software for
firewall user authentication? (Choose two.)
how many virtual routers can be configured on the ERX Edge Router?
Beginning with software version 4-0-0.rel, how many virtual routers can be configured on the ERX
Edge Router?
which parameter is used to determine the new BDR at the time of a DR failure?
If all OSPF routers on a broadcast network have the same OSPF priority, which parameter is used to
determine the new BDR at the time of a DR failure?